Garage Door Garage Door Sensor Installation South Salt Lake, UT

Garage Door Garage Door Sensor Installation South Salt Lake, UT

Booked garage door sensor installation in South Salt Lake, UT? Expect a tech who actually works Salt Lake County: fast dispatch, an honest diagnosis, and parts on the truck for cold-snapped springs after hard winter freezes, dried, cracked bottom seals that let dust into the garage, dust-fouled tracks that bind and throw the door off level, and noisy operation from grit-packed, under-lubricated rollers.

In Utah's semi-arid interior, a high, dry climate of intense summer heat, sharp overnight cooling, and very little annual precipitation. For South Salt Lake garages that translates into fine wind-borne dust that grinds down track rollers, freeze-thaw on cold winter nights that cracks aging seals, and dust storms that pack debris into tracks and photo-eye sensors, so our tune-ups focus on the components that wear first under these conditions.

From Clark Village Gardens, Liberty Acres, Benwood and Green Acres, the issues South Salt Lake customers describe are typically cold-snapped springs after hard winter freezes, dried, cracked bottom seals that let dust into the garage, dust-fouled tracks that bind and throw the door off level, and noisy operation from grit-packed, under-lubricated rollers. We quote flat-rate, fix it in one trip, and back the work for 10 years.

Photo-eye safety sensors are required by UL-325 on every garage door opener manufactured since 1993. They detect obstructions in the door's path and either reverse the door (during close) or refuse to start (when activated). When sensors are misaligned, dirty, sun-blinded, or failed, the door either refuses to close at all or — worse — closes without sensing an obstruction. Our sensor installation service replaces failed sensors, realigns drifted brackets, cleans the eye optics, and verifies auto-reverse on a real obstruction test.

Replacement eyes are brand-specific (LiftMaster has a different connector and signal pattern than Genie). We stock the major brands and most legacy models. Brackets occasionally need replacement when corrosion has degraded them or impact has bent them. Bracket alignment is critical — eyes that are slightly off-aim trigger intermittent close failures that drive homeowners crazy.

Every visit ends with an obstruction test: a 1.5-inch (3.8 cm) tall object placed under the door at three positions across the opening. The door must reverse when it touches the object. This is the UL-325 baseline — if the door doesn't pass, the install isn't complete. We document the test results on the work order.

Signs you need garage door sensor installation